If you have a fault on the Adblue injector or the pump then clearing the code will not help. Needs diagnosed properly and most little garages don't have the kit or the knowledge. An Adblue tank with integrated pump costs about £1500 but it may just be the injector is clogged. Hello, On a Citroen C-Crosser I have P0489,P1162,P1361 and P1728 on engine,P1780 on transmission ans ABS/ESP warning light on. ECU EDC16CP39 was replaced,the car worked for 2 days and now I have the same faults.EGR can't be learned now,is too open (ECU say this). I need fault off for the old ECU to test if EGR is the source of issue. Engine Tapping Noises. I have 2009 Berlingo 1.6 hdi 110 with 66,000 miles, always maintained and never driven hard. The Friday before Christmas I noticed a light hollow tapping noise coming from the engine, I thought it was a noisy tappet but it got worse and louder, like all sixteen tappets are loose, a couple of times I heard a screeching The overboost P0234 code must be the bane of every Berlingo owner on the Planet. I have been struggling to rid my car of this fault but to find out whats causing it is a Night Mare. So I am gradually working through the possible areas. 1. Confirmed overboost fault P0234 indicated and Engine Light on. Mk 2 Berlingo: Low engine oil pressure or high temperature. If the engine is running hot, stop the engine and allow to cool. When cool, check oil levels and top up if required. If temperature and oil levels are correct but the warning light remains on, do not continue driving. Major engine lubrication fault. Contact a Citroën workshop. I have a 2012 Berlingo 1.6 HDi which stopped running, turns out problem was with ECU. A second hand ECU was purchased and programmed for immobiliser etc. Car now starts but comes up with start/stop faults even though it's not a start/stop model of Berlingo. Can this ECU be reprogrammed to remove/bypass the start/stop programming or does it (23-03-2018, 01:43 PM) Silverberlingo Wrote: (23-03-2018, 12:18 PM) SergioFR Wrote: Hi, Are you sure that it has Abs? Check witj your vin number the braking systemn on Peugeot service box and you can follow the system and make a pre—identification of parts. When your OBD-II equipped vehicle exhibits a code P0215, it means that the powertrain control module (PCM) has detected a malfunction in the shutoff solenoid for the engine. Most commonly, the engine shutoff solenoid interferes with the fuel supply to the engine under certain specific circumstances. These circumstances may include (but are not 1OSLEZ.

engine fault citroen berlingo 1.6 hdi